![]() If the debugging does not start, reset the J-Link: Target -> Reset J-Link. When the download is complete, select Debug -> Go again to start the code execution.This downloads the matching SoftDevice and the compiled example, and starts the debugger. Erase the device from the SES options menu: Target -> Erase all.In SES, connect to the development kit with Target -> Connect J-Link.Connect the Development Kit with the USB cable to your computer.To run the examples in a build environment based on SEGGER Embedded Studio (SES): The following procedure only works if you have built the example with SEGGER Embedded Studio. Running examples using SEGGER Embedded Studio Interacting with examples using SEGGER RTT.Running examples using custom CMake target. ![]() Running examples in CMake-based build environment.Running examples using SEGGER Embedded Studio.See the documentation for each example for more information. For some examples, additional steps might be required.The following procedures are not applicable for the DFU example.Once you have an example running, you can interact with it through command line with SEGGER RTT. Just as with installing the toolchain and building the Bluetooth mesh stack and examples, the procedure for running examples depends on the IDE. This page describes how to run examples included in the nRF5 SDK for Mesh package.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |